Fault Description / Instruction:
- Check the AC connections and AC frequency is in range
- Check the measured frequency value on the LCD, if within limit,restart the inverter
Customer Solution Portal
Related Articles
- Warning - Warn0030 - EepromErr
- Warning - Warn0050 - TempSensorErr
- Alarm - TempSensorErr
- Alarm - CommErr
- Alarm - ExtFanErr
- Alarm - EepromErr
- Protection - Protect0090 - Bus over voltage
- Protection - Protect0070 - Bus Imbalance
- Protection - Protect0030 - Inverter Over Current
- Protection - GridV.OutLim
- Protection - Protect0020 - Grid Relay Error
- Protection - TempOver - Over-temperature protection
- Protection - Protect0180 - The sampling offset of DCI
- Protection - Protect0170 - DCI High
- Protection - TempOver - Over-temperature protection
- Protection - Protect0180 - The sampling offset of DCI
- Protection - Isolation Err. - Insulation resistance low
- Protection - GFCIErr - Leakage Current High
- Protection - Protect0150 - Mini MCU Fault
- Protection - Protect0110 - BUS over voltage (firmware)
- Protection - Protect0100 - The sensor fault of leakage current
- Protection - PVxReverse - (PVx input reverse connection x=1/2/3)
- Protection - PVx Over current - (PVxOver current x= 1/2/3)
- Protection - PV2VoltOver - (PVx Over Volt x= 1/2/3)
- Protection - Protect0230 - Inverter open-loop self-test fault
- Protection - ARC Protect
- Protection - Arcboard Error
- Fault - Fault 0020 - Bus Over Volt Hardware
- Fault - Fault0060 - CPLD Fault