Description - Boot jumper installed
Problem Indicated - Applies to jumper 3rd up from the bottom on DSP PCBA. If this jumper is installed, the inverter will always be in boot jump mode. (Resettable)
Customer Solution Portal
Related Articles
- Fault - 1 - Array
- Fault - 2 - Grid
- Fault - 3 - System
- Fault - 4 - Drive
- Fault - 5 - Temp.
- Fault - 6 - Disabled
- Fault - 7 - IAC
- Fault - 8 - IDC
- Fault - 9 - PAC
- Fault - 10 - VDC High
- Fault - 11 - VDC Low
- Fault - 12 - IHARM
- Fault - 13 - Cool Temp
- Fault - 14 - Cooling
- Fault - 15 - Interlock
- Fault - 16 - Power Supply
- Fault - 17 - Latched
- Array Fault - 1 - Asymmetrical Array
- Array Fault - 2 - VDC High
- Array Fault - 3 - PV Overvoltage
- Array Fault - 5 - Array reference position
- Array Fault - 6 - PV Ground overcurrent
- Array Fault - 7 - PV/Bus Voltage measurement mismatch
- Grid Fault - 1 - Phase Order
- Grid Fault - 2 - Slow Low Frequency
- Grid Fault - 3 - Slow High Frequency
- Grid Fault - 4 - Slow aggregate high AC voltage
- Grid Fault - 5 - Slow Aggregate low AC voltage
- Grid Fault - 6 - Slow positive sequence voltage high
- Grid Fault - 7 - Slow Positive Sequence Voltage Low